MeshCore/Flash Room Server: Difference between revisions
MrAlders0n (talk | contribs) No edit summary |
MrAlders0n (talk | contribs) No edit summary |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
__NOTOC__ | __NOTOC__ | ||
[[Main Page|← Home]] | [[Main Page|← Home]] | ||
Follow these steps to flash and configure a device as a MeshCore Room Server: | Follow these steps to flash and configure a device as a MeshCore Room Server: | ||
== Flashing the Firmware == | == Configuring a Room Server == | ||
=== Flashing the Firmware === | |||
1. Open the MeshCore Web Flasher: [https://flasher.meshcore.co.uk/ Link] | 1. Open the MeshCore Web Flasher: [https://flasher.meshcore.co.uk/ Link] | ||
| Line 26: | Line 25: | ||
If this happens, refresh the page, click '''Enter DFU Mode''' again, and then click '''Flash''' to retry. | If this happens, refresh the page, click '''Enter DFU Mode''' again, and then click '''Flash''' to retry. | ||
== Configuring the Room Server == | === Configuring the Room Server === | ||
8. After the flash is complete, click '''Configure via USB'''. | 8. After the flash is complete, click '''Configure via USB'''. | ||
| Line 42: | Line 41: | ||
14. Click '''Reboot'''. | 14. Click '''Reboot'''. | ||
== Final Steps == | === Final Steps === | ||
15. Connect back to the device via the console. | 15. Connect back to the device via the console. | ||
Latest revision as of 19:53, 2 September 2025
Follow these steps to flash and configure a device as a MeshCore Room Server:
Configuring a Room Server
Flashing the Firmware
1. Open the MeshCore Web Flasher: Link
2. Select your device from the list.
3. Select Room Server.
4. Click Enter DFU Mode.
5. Click Erase Flash and wait for it to complete.
6. Select your desired version (the most recent is generally recommended).
7. Click Flash.
Note: Sometimes after erasing, the flash step may fail.
If this happens, refresh the page, click Enter DFU Mode again, and then click Flash to retry.
Configuring the Room Server
8. After the flash is complete, click Configure via USB.
9. Select your console device and click Connect.
10. Set a descriptive name for your Room Server.
11. Set both a guest password and an admin password.
12. Choose your radio preset: in Ottawa use USA/Canada (Recommended).
13. Click Save Settings.
14. Click Reboot.
Final Steps
15. Connect back to the device via the console.
16. Click Send Advert.
17. On your companion node, it should now discover your Room Server.
18. Log in from your companion node to the Room Server using the guest password.