MeshCore/Flash Room Server: Difference between revisions
MrAlders0n (talk | contribs) Created page with "__NOTOC__ ← Home = Configuring a Room Server = Follow these steps to flash and configure a device as a MeshCore Room Server: == Flashing the Firmware == 1. Open the MeshCore Web Flasher: [https://flasher.meshcore.co.uk/ Link] 2. Select your device from the list. 3. Select '''Room Server'''. 4. Click '''Enter DFU Mode'''. 5. Click '''Erase Flash''' and wait for it to complete. 6. Select your desired version (the most recent is generally recom..." |
(No difference)
|
Revision as of 16:59, 2 September 2025
Configuring a Room Server
Follow these steps to flash and configure a device as a MeshCore Room Server:
Flashing the Firmware
1. Open the MeshCore Web Flasher: Link 2. Select your device from the list. 3. Select Room Server. 4. Click Enter DFU Mode. 5. Click Erase Flash and wait for it to complete. 6. Select your desired version (the most recent is generally recommended). 7. Click Flash.
Note: Sometimes after erasing, the flash step may fail. If this happens, refresh the page, click Enter DFU Mode again, and then click Flash to retry.
Configuring the Room Server
8. After the flash is complete, click Configure via USB. 9. Select your console device and click Connect. 10. Set a descriptive name for your Room Server. 11. Set both a guest password and an admin password. 12. Choose your radio preset: in Ottawa use USA/Canada (Recommended). 13. Click Save Settings. 14. Click Reboot.
Final Steps
15. Connect back to the device via the console. 16. Click Send Advert. 17. On your companion node, it should now discover your Room Server. 18. Log in from your companion node to the Room Server using the guest password.